VVD New Version 9.42
The new version 9.42 was released in mid December and includes a number of new calculation modules and enhancements. Version 9.42 is also incompliance with EN13445 issue 12 and PD5500 Amendment No. 15207.
Version 9.42 - General
Version 9.42 is now incompliance with EN13445 issue 12 and PD5500 Amendment No. 15207.
- Recently used materials can now be displayed separately for more efficient use of the material database
- Default file catalog have been included
- Added a new table for recommended nozzle standout based on flange type and rating
- Added a new table for dimensions of tubing
and much more...
Version 9.42 - 3D Module
- Tubes in heat exchangers are included in the 3D drawing
- Fillmode Transparent added
- Fillmode Solid+Wireframe added
- Clipmode in all 3 planes xy, xz and yz added
- Reinforcement pads on nozzles located both in shells and ends are now included in the 3D drawing
- Legs on vertical vessels are now included in the 3D drawing
- Lifting trunions are now included in the 3D drawing
Version 9.42 - EN13445
- Added a new module for design of Lifting trunions
- Added a new module for design of Legs on vertical vessels
- Material groups are now printed with the material data
Version 9.42 - ASME VIII Div.1
Added new modules for:
- Expansion bellows to Appendix 26
- Lifting trunions
- Legs on vertical vessels
- Autodetect for nozzles located close to discontinuities
- All material notes added and can be viewed and printed with the material data
- E-module for ASME materials can be obtained at any temperature
Version 9.42 - PD5500
Added new modules for:
- Lifting lugs
- Lifting trunions
- Bracket support
- Legs on vertical vessels
Download PDF version of this page